UCCS | Smart Classrooms

Smart Classrooms

Smart Classrooms Home open all / close all General Information

Getting Started Student Employment

Engineering

All Classrooms

Other Buildings

Centennial Hall Columbine Hall Cragmor Hall Dwire Hall Science and Engineering University Hall

IT Home

Audio-Visual Controls - Engineering 101, 103, 105, 107, 109

1. Turn on the projector using the control panel and lower the screen.

This is the button used to control the screen.

2. Prepare Media and login.

3. Select projector input.

Control Panel
	1. Press "on" to turn the projector on. Note: The "on" button will flash while the projector is warming up. You must wait until the button stops flashing to input additional commands. 2. Select your input: VCR/DVD: To show a video from the VHS-DVD deck, press "VCR/DVD." Adjust the volume with the volume control dial. Aux Video (Auxillary Video): Connect your auxillary video device per the directions below. Press "Aux Video" to show your media. Portable PC (laptop): Connect your laptop per the directions below. Press "Portable PC" to show your laptop screen. PC (Podium Computer): Press "PC" to projector the podium PC. 3. The volume control dial is located below the projector "on" and "off" buttons. 4. When you select your input, you may notice the projected image will flicker and go blank for 5-10 seconds. This is normal; you do not need to do anything.

Control Panel

1. Press "on" to turn the projector on. Note: The "on" button will flash while the projector is warming up. You must wait until the button stops flashing to input additional commands.

2. Select your input:

VCR/DVD: To show a video from the VHS-DVD deck, press "VCR/DVD." Adjust the volume with the volume control dial.
Aux Video (Auxillary Video): Connect your auxillary video device per the directions below. Press "Aux Video" to show your media.
Portable PC (laptop): Connect your laptop per the directions below. Press "Portable PC" to show your laptop screen.
PC (Podium Computer): Press "PC" to projector the podium PC.

3. The volume control dial is located below the projector "on" and "off" buttons.

4. When you select your input, you may notice the projected image will flicker and go blank for 5-10 seconds. This is normal; you do not need to do anything.

4. Start media.

Zenith DVD/VHS Remote Control
	Use the controls on the DVD/VHS deck itself for basic operation (play, stop, rewind and fast forward). For advanced options such as browsing a DVD menu, use this remote control.